Talkswitch TS-600 User Manual download pdf (Page 10)

6 WWW.TALKSWITCH.COM

TS-600 USER GUIDE

CONFIGURE THE OUTSIDE LINE ACCESS CODE

The outside line access code is dialed prior to any

number over 6 digits stored in the directory, speed

dial buttons, or the call log. A stored number with

6 or fewer digits is considered an internal number.

The outside line access code is not dialed for an internal

call. A 3 second pause is inserted automatically between

the outside line access code and the phone number.

Extensions with Direct Line Access

Direct Line Access allows you to access the outside phone lines directly, without

having to enter a line access code. If your TalkSwitch extension is programmed

for Direct Line Access, enter as your line access code. This will ensure that

features and dialing operate properly for your extension. Refer to your TalkSwitch

programming guide for more information.

To enter outside line access code:

1. Press the button followed by .

2. Enter your outside line access code or if your extension is configured for

Direct Line Access.

3. Press the button to store the access code.

Selecting ring tone

You can select one of four ring tones for

this telephone:

1. Press the button followed by .

2. The phone rings with Ring Tone 1 for about

2 seconds.

3. Press the button to select Ring Tone 1; or

4. Press the S button or the T button to select another ring tone.

5. After the end of the desired ring tone, press the button to select it.

Adjusting the display angle

You can optimize the LCD display by adjusting the viewing angle. To adjust the

LCD viewing angle, move the rear edge of the LCD module up or down.

SAVE

Use Save to End

# = DLA Mode Enable

Enter Access Code

Use Save to End

Use S/

Enter to Select

1 = Ring tone 1

2 = Ring tone 2

3 = Ring tone 3

4 = Ring tone 4

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 29 30

Comments to this Manuals

No comments

Talkswitch TS-600 User Manual Page 10

Comments to this Manuals